Ultimate RC - Forum Archives


PDA
You are viewing an archive version of a topic

Click here to view the full version : Need cash - hopped up MGT4.6 FS (MGT - SOLD)


Original Phatty
7.14.07, 3:32 pm
Hopped up MGT 4.6 Never bashed hard or raced. Just have it set up to do so. Mostly diving around the school yard across the street from my house. I broke my foot over a year ago, and was laid up for 4 months in a cast so I got into RC and started building MGT trucks. This is the second one that I build over the past winter.

I really don't need or have time for two trucks any more, plus I need cash to buy Kitesurfing gear.

MGT Basher - Set up more for Big Jumps and off road.
XTM 24.7 w/ new carb and crank not sure how much fuel has been run through it. I have personally put 1/2 gallon it it but would guess it has a lot more. Still runs really Strong and fast. LST 2 Clutch installed.

Tranny (4.6 w/ metal gears) w/center CVDs, slipper & spur, clutch (lst2 clutch w/ aluminum shoes), servos, aluminum shock caps, stock brake setup, XTM pipe, all 4 CVD, Venom failsafe, carb and servo saver were all new less then a 1/2 gal ago.

New bearings in rear diff w/ 5k diff fluid.

Upgrades:
-Both diffs Shimmed
-RPM Upper A-arms, stock lower
-TowerPro servos 180oz (steering and throttle)
-23mm Adapters
-Factory Team Shock Caps
-Factory Team Tie Rods
-AE Side header
-XTM Mammoth Pipe
-Proline Cheyenne w/ Big Joes
-4 copper (extra firm) and 4 red (firm) shock springs
-Dubro inline fuel filter and fuel line
-LST2 Clutch and Flywheel w/ aluminum shoe


Replacement parts NIB:
4 - stock Knuckles
8 - gold Springs (medium)
16 - blue Springs (soft)


Replacement parts used:
-Proline Wabash narrowed with traxxas Response (Well Used see pics, Great for bashing)
2 - red springs 2 copper
3 - shock towers w/ body mounts and posts
hinge pins
5 - upper arms


MICS. Parts Included.
-New set of 4 Losi Aftershock shocks and 2 towers. Tried to make a mod to put these on the MGT with only mild success. Maybe you will have better luck. with teCk's and the Dudes mod coming soon
-23mm 1/2 socket for the 23mm adapters

link to large photos: http://www.vanderzeedesign.com/MGT/
click on pic name to see pic

Had planned on trading this stuff a while back but it never worked out.

Looking for $350 shipped to lower 48.

Will not shop over sees. I will include everything pictured and more if I find anything else before it ships.

Thanks for looking jake
...graphics_13...@...hotmail.com - remove (...)

Break 1.8T Sync
7.18.07, 3:17 pm
Would you sell just the Cheyenne/big joe combo?

Thanks

jogging789
8.19.07, 3:45 pm
i will give u 350 for it

Original Phatty
8.19.07, 3:53 pm
Jogging-

Bummer you're a little late. Wish i could sell it to you but i just traded it for a mammoth a couple weeks ago since it wasn't moving. sorry, i could have used the cash...

jake

jogging789
8.19.07, 3:54 pm
would that mammoth for 575

Original Phatty
8.19.07, 4:01 pm
would that mammoth for 575
a little confused? PM me.

jogging789
8.19.07, 4:17 pm
yes i wanna buy ur mammoth

Original Phatty
8.19.07, 4:22 pm
Where would I be shipping to?

I am off to get some pics for you. Will be back in a few with a link to the pics.

jogging789
8.19.07, 4:31 pm
ok

Original Phatty
8.19.07, 6:02 pm
Jogger clear out you PM box. It says it is full. buy the way, I would love to get $575 for it but I wouldn't want to over charge you. PM me you email and I will send you my Paypal address

Original Phatty
8.19.07, 6:13 pm
Jogger here is the list your PM box is still full:

Shoot me you email and i will send you the list there as well.

I am very picky about my trucks so when I got this one and it was dirty, I decided I needed to clean it. 4 hours later it looked like new. I have yet to drive it i have been busy with work and replacing parts to make it like new.

From the guy I just traded my MGT for ,about the Mammoth's run time:
"In all honesty the truck does not have much time on it, figure about 10 practice runs @ 7 mins. a piece 6 qualifying at 5 mins. 2 A mains @ 10 mins and some practice time before the event."
The truck is from Florida looks almost like new

I have yet to open the diffs so will send a bottle of 5000w diff oil just incase they need to be refilled

Engine: Same as the one listed in the MGT ad
XTM 24.7 w/ new carb and crank not sure how much fuel has been run through it. I have personally put 1/2 gallon it it but would guess it has more. Still runs really Strong and fast. LST 2 Clutch /aluminum shoes installed. XTM Mammoth pipe with 1/2gallon installed.


New Parts I installed have not run yet:
- Proline Wabash 17mm 40 series wheels (still need to be glued)
- Center 2 spd tranny with all new bearings and output cups
- Front CVDs rebuilt
- Orion Flat 5 cell receiver pack
- 945 tower pro servos for st & th (180 oz from jason on the forum)
- Receiver box
- Left front shock shaft
- Exhaust manifold (had sitting around from the pipe I had put on the MGT)
- Air filter
- 2 body mounts
- Dubro inline fuel filter and fuel line (red)
- 60w oil in all the shocks


New parts not installed:
- 17mm Hubs from Hyper 8 (black) I don't like the stock silver ones.
- Extra Shock shaft
- Chassis
- Upper chassis
- Chassis braces
- Front and rear shock towers
- 2 body mounts
- Extra Battery box


Used parts not installed
- 2 spd tranny missing one 2nd spd bearing the other one seems a little loose and output cups
- 4 maxx size 17mm wide offset Truggy wheels (chrome is wearing off but the hexes are in great shape might be proline rims)
- Set of stock xtm wheels that I narrowed (Decided after trying to narrow a tire i wasn't too good at it)
- Stock MGT Associated radio with 2 receivers and crystal sets.
- XTM Pipe and exhaust manifold
- Tiger drive (need a new back plate for the 24.7 to use it)
- 1 complete carb
- 1 parts carb
- Extra cooling head
- Flywheel & clutch
- Extra MGT airfilter

I am thinking $435 shipped for everything listed.

$385 w/o the receiver pack and wabash wheels.

Add 3% if you pay through paypal with a credit card.

Or you could send me a US Post office money order (I will only except one from the USPS no banks, or western union) and when it clears I will send you the truck.

Battery in my camera just died as I was taking pics, as soon as it charges I will finish getting what I need and send you a link

jogging789
8.19.07, 6:46 pm
i will give u 435 for it but i don't have a paypal account but can send u a chech or cash money but i need to find out when u can ship big race comin up and want to enter it

Original Phatty
8.19.07, 7:08 pm
Overnight me a USPS MO or Cash (if you feel safe doing the cash thing in the mail) and I will ship it as soon as the MO or Cash gets here. I will get it all boxed up tomorow. Then I will bring it to work with me. On Tuesday after I get the Overnight package at my office I will ship it on my lunch break.

You should have it by Thursday, possible Weds, I think DHL MI to WI is only one day.

Just to be clear I will only take a MO from the USPS (will validate with them that it is legit) or Cash, and if it is cash, you are taking on that risk, so I would insure it for full value when you send it.

I will not send until i have cash in hand.

email me: graphics_13>>at<<hotmail.com (replace >>at<<) and I will email you my work address and contact info to you

thanks

Original Phatty
8.19.07, 7:25 pm
here is a link to some images. They should be done uploading in a few minutes. Just click on the file names to see the images.

http://vanderzeedesign.com/MAM/

jogging789
8.19.07, 7:43 pm
ok do u have any other trucks u would wanna trade for a tmaxx 3.3

Original Phatty
8.19.07, 7:50 pm
no I don't sorry.

jogging789
8.20.07, 5:46 am
ok

Original Phatty
8.22.07, 4:18 pm
So what's up? I thought you said you sent money. I have had it boxed up for 2 days?

What's going on?