Other way around, short soft, long stiff. You want the short one to be able to compress fully.

Thank you for the info on that, but is there a special way to cut springs down, or do you just cut it?

Well tomorrow night I am going to work on the new chassis, spent the weekend designing it. I screwed up on the original plate.

The design seems like it should work.

Update tomorrow on the progress.

I just cut them, not sure if I do it right or not.

I didn't get home al that fast. 7:30 pm.
So I didn't get anything done that is able to be shown. I did get a little done but it was on pen paper. The to chassis plates, horizontal ones that is, have been drawn up.
Going to have to print off some templates tomorrow, (don't hold me 2 it).

If anyone wants to see the drawing I can show it tho.

Well this weekend i got the parts order to turn this little guy into a roller/runner. Hope to get a test run in this weekend if possible, but things can always come up tho.