P-Q Bags - Final Assembly
So I actually had to rotate the switch 90° in order for it to get around the pinion gear, kind of a tight fit but not really anywhere else to mount the switch that I can see, ha!
It's kind of hard to see, but the sensor wire comes out the end bell of the motor and it almost rubs on the ESC, I will have to keep an eye on this and hope it doesn't prematurely wear... there really is no physical room to move anything around, the 2000kV Gool RC 4274 motor
fits like a glove with all the other components. I upgraded to a 25T aluminum servo horn and went with a 100mm sensor cable. I also went with a 4500mAh SMC 4S LiPo but didn't realize the pack would be significantly smaller than traditional 4S packs and the velcro straps have tons of left over strap after fastening the pack... though the straps still work fine I am worried that the weight might be a pinch too light... regardless I do plan on adding some weight to the rear of the chassis anyway.
I don't plan to use the white wing nor steel body clips that come with the kit, I ordered a yellow wing and will be using EDS clips which have an angled front which reduces the chance of losing a clip in the event of a crash... I can't tell you how many clips I lost on my RC8T3e... that was VERY annoying!
Freshly painted with my racing color scheme, tuned with all my first guess setup settings and ready to hit the track! Not sure if the track will be open for practice tomorrow being Father's Day, but due to family plans, I will miss the next scheduled race for 6/24 and due to a weird mix of big races the track will be hosting, I might not actually get to race this truggy for the first time until the middle of August... argh!
(Last edited by BillDeLong : 6.17.17 at 2:35 pm)
eTruggy + eBuggy + 4WD Mod SC + 4WD Mod ST + 2WD Mod ST + 4WD 13.5T Buggy + 2WD 17.5T Buggy + Spec Slash