I just got a slash 4x4 platinum LCG edition and i broke an a arm.After that i went to my local hobbie store and bought green RPM a arms.I put them on and when i jump the suspension goes down but then only comes up a little bit.I took the a arms off then drilled the wholes a little bit bigger so that the pin that holds them in would slide easily inside.I drove it.That wasnt the problem.Does anyone know what it could be.

Binding in the dtiveshafts maybe?

Didn't do this before, I'm assuming.

Maybe you tightened the pin for the caster block too tight...

possibly it was realy hard to get it the bolt when through the aluminum

slitly bent shock shaft?

Yep has to be either a bent shock shaft or bent suspension pin.

Does it cycle smoothly when you pick it up? If so you might have put the shock in a different position on the lower arm

Cam

yes it does cycle smoothly when i pick it up.That shaft isnt bent.
and it does it all around the car front and back

I might have a problem like that with one of my new slash. The body rums on the tires. Even more so when I go in reverse. I'm new to this so I have not pin pointed what I think it could be yet. Going forward it makes little noise but gong in reverse it just wants to touch the body. It did not do that when it was new out of the box. My kids have been crashing a lot tho.

yeah mine didnt do it out of the box either u upgraded that a arms to green RPM.....Maybe when i put the sawy bars and shocks back onto the new a arms i didnt put them in the rite hole.Does anyone know what holes they should be in?